Brother International Innov-ís 1500D Users Manual - English - Page 62
When Sewing Straight Stitches While Using, the Side Cutter
View all Brother International Innov-ís 1500D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
d Select a stitch. h Start sewing. SEWING THE STITCHES → A seam allowance is cut while the stitching is sewn. Note If the width has been adjusted, turn the handwheel by hand to check that the needle does not touch the side cutter. If the needle touches the side cutter, it might cause the needle to break. e Make a cut of approximately 20 mm (approx. 3/4 inch) in the fabric. ■ When Sewing Straight Stitches While Using 3 the Side Cutter The seam margin should be approximately 5 mm a (approx. 3/16 inch). Utility Stitches a 20 mm (approx. 3/4 inch) f Position the fabric so that the right side of the cut is on top of the guide plate and the left side of the cut is underneath the presser foot. a b a Guide plate (lower knife) b Presser foot g Thread the needle manually and pull out a long section of the upper thread. Pass it below the presser foot and pull it out in the fabric feed direction. b a a Presser foot b Upper thread a a Seam margin Memo • The fabric will not be cut if the whole fabric is simply spread out underneath the presser foot guide plate. Set the fabric as explained in step f from the previous section, and then start sewing. • One layer of 13 oz. denim can be cut. • Clean the side cutter after use to avoid having dust and scraps of thread build up on it. • Add a small amount of oil as required to the cutting edge of the cutter. 61