Brother International PC-8500 Users Manual - English - Page 63

Setting Up Sewing Utility Stitches Characters and Decorative Stitches Embroidering DARNING 1 2 2 1 4 4 3 5 3 5 3 5 A 1 Medium fabric 2 Thick fabric 1. Set the stitch length using the scale on presser foot "A". 1 Scale on the presser foot 2 Button holder plate 3 5 mm (3/16") at "2" on scale 4 Length of darning is equal to scale setting. 5 Width [7 mm (1/4")] * The maximum stitch length for darning is 3 cm (1-3/16"). 2. Check the needle drop point and then lower the presser foot. * After the presser foot lever has been lowered, set the presser foot so that there is no gap behind the section marked with an "A", otherwise the size of the stitch will not be correct. To do A this, push the presser foot towards the back of the machine as shown in the left figure. * Pass the thread underneath the presser foot. 3. Lower the button hole lever to set it behind the metal bracket. 1 Metal bracket Editing Embroidery Patterns Retrieving My Custom Stitch TM Error Maintenance Messages Trouble shooting Sewing Chart 1 3 5 4. Start sewing while holding the upper thread by hand. * The machine stops automatically after sewing a reinforcement stitch. * When automatic thread cutting is set, the machine trims both threads automatically after sewing is completed. 60 Patterns (Programmed in Machine) Patterns (Memory Card)