Brother International Z-8550A Instruction Manual - English - Page 65
Changing the feed amount to long stitch specifications (from 2.0mm to 5.0mm)
View all Brother International Z-8550A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
11. REPLACING PARTS 11-2-2. Changing the feed amount to long stitch specifications (from 2.0mm to 5.0mm) 1. Replace the feed dog (1) and needle plate (2) with the ones for long stitches. 2. After this, change the maximum feed amount as described below. 3498M 11-2-3. Changing the maximum feed amount If the feed dog has been replaced by one that does not match the feed amount that is currently being used, the feed dog may touch the needle plate if the stitch length dial or condense dial are mistakenly set to settings that are larger than the maximum feed amount for the feed dog, and this could cause problems such as damage or noise. In order to prevent dial setting errors such as this, change the maximum feed amount setting for the sewing machine to match the maximum feed amount for the feed dog. 1. Tilt back the machine head. 2. For models/specifications other than the 8550A-031, loosen the two screws (1) so that the quick reverse solenoid (2) can be moved up and down. 3499M 3. Loosen the screws (3) and (4). 4. Move the stopper (5) down as far as possible, and move the stopper (6) up as far as possible 3500M 5. Turn the stitch length dial (7) and the condense dial (8) to the maximum feed amount for the feed dog being used. (Set the condense dial (8) to a negative number.) 3501M 57 Z-8550A, 8560A