Brother International Z-8550A Instruction Manual - English - Page 72
Adjusting the needle bar height, 12-9. Needle and rotary hook timing, STANDARD ADJUSTMENTS
![]() |
View all Brother International Z-8550A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
12. STANDARD ADJUSTMENTS 12-8. Adjusting the needle bar height 3521M Touching For the 8560A (Fig. A) With the accessory needle bar height gauge (2) installed to the needle bar (1), adjust so that the needle bar height gauge (2) is touching the top of the needle plate (3) when the needle bar is at its lowest position. 1. Remove the needle (4) and the presser foot (5). For the 8560A (Refer to Fig. A) 1) Remove the needle plate (3) and then auxiliary needle plate (6). 2) Remove the spacer (7). 3) Place the needle plate (3) onto the needle plate installation surface. 2. Install the accessory needle bar height gauge (2) to the needle bar (1), and then tighten it with the set screw (8). 3. Loosen the screw (9). 4. Move the needle bar up or down to adjust so that the needle bar height gauge (2) is touching the top of the needle plate (3) when the machine pulley is turned so that the needle bar (1) is at its lowest position. 5. Securely tighten the screw (9). 6. Remove the needle bar height gauge (2). 7. For the 8560A, install the spacer (7), needle plate (3) and auxiliary needle plate (6). 8. Install the presser foot (5) and needle (4). 3522M 12-9. Needle and rotary hook timing 3523M 1. Turn on the power switch. 2. Press the TEST key (1) and check that the TEST icon (2) is illuminated. (For safety purposes, be sure to carry out this step, as it prevents the motor from operating even if the treadle is depressed.) 3. Set both the zigzag width and the zigzag base line position to "0". (Refer to pages 31-32.) (Continued on next page) Z-8550A, 8560A 64
![](/manual_guide/products/brother-international-z8550a-instruction-manual-english-72b346d/72.png)