Campbell Scientific 10525 ENC10/12, ENC12/14, ENC14/16, ENC16/18 Enclosures - Page 44

C.2 Mounting Procedure

Get Campbell Scientific 10525 PDF manuals and user guides View all Campbell Scientific 10525 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

Appendix C. 28960 Stack Mounting Kit C.2 Mounting Procedure 1. Determine the spacing needed between the two legs. 2. Secure the legs to the back plate using screws and grommets. If a component is to be mounted under another and shares the same mounting holes as the leg, mount the pieces in the following order. Back Plate < Grommet < Leg < Component < Screw 3. Fully wire the bottom component before proceeding. 4. Place the Top Grid in position over the Legs. Insert Grommets where required for the component to be mounted. If the Top Grid is not going to be used, insert the Grommets directly into the top of the Legs. 5. Place the top component in position and secure it with Screws. C-4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Appendix C.
28960 Stack Mounting Kit
C-4
C.2
Mounting Procedure
1.
Determine the spacing needed between the two legs.
2.
Secure the legs to the back plate using screws and grommets. If a
component is to be mounted under another and shares the same mounting
holes as the leg, mount the pieces in the following order.
Back Plate < Grommet < Leg < Component < Screw
3.
Fully wire the bottom component before proceeding.
4.
Place the Top Grid in position over the Legs. Insert Grommets where
required for the component to be mounted. If the Top Grid is not going to
be used, insert the Grommets directly into the top of the Legs.
5.
Place the top component in position and secure it with Screws.