Campbell Scientific CR1000KD CR800 and CR850 Measurement and Control Systems - Page 295

Section 8. Operation • Effects due to the following are not included in the specification: o Bridge-resistor errors o Sensor noise o Measurement noise The ratiometric-accuracy specification is applied to a three-wire half-bridge measurement that uses the BrHalf() instruction as follows: The relationship defining the BrHalf() instruction is X = V1/Vx, where V1 is the voltage measurement and Vx is the excitation voltage. The estimated accuracy of X is designated as ∆X, where ∆X = ∆V1/Vx. ∆V1 is derived using the following method. The ratiometric-accuracy specification is applied to a four-wire full-bridge measurement that uses the BrFull() instruction as follows: The relationship defining the BrFull() instruction is X = 1000*V1/Vx, where V1 is the voltage measurement and Vx is the excitation voltage. Result X is expressed as mV/V. Estimated accuracy of X is ∆X, where ∆X = 1000*∆V1/Vx. ∆V1 is derived using the following method. ∆V1 is derived using the ratiometric‐accuracy equation. The derivation is illustrated in this example, which is supported by the assumption that the measurement is differential with input reversal, datalogger temperature is between ‐25° to 50°C, analog‐input range is ±250 mV, V1 = 110 mV, and excitation is reversed during the excitation phase of the measurement. The effect each assumption has on the magnitude of ∆V1 in this example is noted in the following figure. Figure 91: Deriving ∆V1 295