Campbell Scientific CR1000KD CR800 and CR850 Measurement and Control Systems - Page 99
Datalogger Sub-Tab, ComPorts Settings Sub-Tab
View all Campbell Scientific CR1000KD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Section 7. Installation Datalogger Sub-Tab • Serial Number displays the CR800 serial number. This setting is set at the factory and cannot be edited. • OS Version displays the operating system version that is in the CR800. • Station Name displays the name that is set for this station. The default station name is the CR800 serial number. • PakBus® Address allows users to set the PakBus® address of the datalogger. The allowable range is between 1 and 4094. Each PakBus® device should have a unique PakBus® address. Addresses >3999 force other PakBus® devices to respond regardless of their respective PakBus® settings. See the PakBus® Networking Guide (available from Campbell Scientific) for more information. • Security - See Security (p. 70). ComPorts Settings Sub-Tab As shown in figure DevConfig Deployment | ComPorts Settings Tab (p. 100), the following settings are available for comports. Read More! PakBus® Networking Guide available at www.campbellsci.com. • Selected Port specifies the datalogger serial port to which the beacon interval and hello-setting values are applied. • Beacon Interval sets the interval (in seconds) on which the datalogger will broadcast beacon messages on the port specified by Selected Port. • Verify Interval specifies the interval (in seconds) at which the datalogger will expect to have received packets from neighbors on the port specified by Selected Port. A value of zero with automatically result in one of two outcomes: o a five-minute verify interval if the neighbor also has 0 set as the Verify Interval argument, or o the verify interval of the neighbor will be adopted if it is non-zero. • Neighbors List, or perhaps more appropriately thought of as the "allowed neighbors list", displays the list of addresses that this datalogger expects to find as neighbors on the port specified by Selected Port. As items are selected in this list, the values of the Begin and End range controls will change to reflect the selected range. Multiple lists of neighbors can be added on the same port. • Begin and End Range are used to enter a range of addresses that can either be added to or removed from the neighbors list for the port specified by Selected Port. As users manipulate these controls, the Add- and Removerange buttons are enabled or disabled depending on the relative values in the controls and whether the range is present in or overlaps with the list of address ranges already set up. • Add Range will cause the range specified in the Begin and End range to be added to the list of neighbors to the datalogger on the port specified by 99