Canon DIGISUPER 60 xs manual for XJ100x9.3B AF XJ100x9.3B XJ95x12.4B XJ95x8.6B - Page 50
Removing and, Installing the Lens, Shroud, 4 Iris Gain Adjustment
![]() |
View all Canon DIGISUPER 60 xs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
2 PREPARATION 5 Bring the object into focus by focus operation. 6 Set the lens to the widest angle. 7 Loosen the F.B. lock knob, and then turn the F.B. adjusting knob to bring the object into focus. 8 Repeat steps 4 to 7 several times, until the object is brought into focus at both the widest angle and telephoto ends. 9 After making sure that the object is in sharp focus, tighten the F.B. lock knob. Knob type 1 Turn the shroud mounting knobs on the bottom of the lens shroud counterclockwise. 2 Hold two recessed handles on both side of the lens shroud, and then pull and remove the shroud from the lens body. Recessed Handle (Both sides of the lens) Lens Shroud The adjustment procedure is now completed. 2-3 Removing and Installing the Lens Shroud Shroud mounting knobs 3 When putting the lens shroud back on the lens body, align the shroud to the guide rails of the lens body, and then push the shroud until it is stopped at the end of the mount. Turn the shroud mounting knobs on the bottom clockwise. When any electrical setting or adjustment is required, remove and install the lens shroud following the steps below. Fastener type 1 Release the fasteners on both sides of the lens shroud, then pull the shroud forward to remove from the lens body. 2 When installing the lens shroud back in place, align the shroud to the guide rails of the lens body, and then push the shroud until it stops at the end of the mount. Press the shroud fasteners near to the end of the mount side to lock the shroud. Recessed Handle (Both sides of the lens) Fastener Lens Shroud * (NOTE) With the lens shroud mounted on the lens, check that the shroud mounting knobs are secured tightly at all times. If these knobs are not perfectly tight, the lens shroud may work free from the main unit and drop off when the camera is tilted down. 2-4 Iris Gain Adjustment The iris gain is set to the middle of the adjusting range at the factory. However, if the iris gain needs to be changed for some reason, follow the steps below. These steps can be taken by the trimmer adjustment or on the information display. (The setting implemented last takes precedence) * (NOTE) For other iris adjustment such as iris ends adjustment or video level adjustment when the extender is used, contact Canon dealer or your Canon sales representative. * (NOTE) Make sure that the fasteners of the lens shroud are always locked when it is mounted on the lens. E8
![](/manual_guide/products/canon-digisuper-27-manual-xj100x93b-af-xj100x93b-xj95x124b-xj95x86b-xj86x93b-af-xj80x88b-xj76x9b-xj60x9b-xj27x65b-af-xj27x65b-56cca24/50.png)