Canon REALiS LCOS WUX500ST WUX500ST Users Manual - Page 160
projection] > [Destination projector setting] > [Confirm] and check
![]() |
View all Canon REALiS LCOS WUX500ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
Advanced Projection • [Destination projector setting] Specify Secondary projector IP addresses. • [Slideshow interval] Specify the slideshow interval (5 seconds to 10 minutes). • [Animation effect] Specify the transition to use for slideshows. 5 On the Primary projector, select [Input settings] > [PC-free multi projection] > [Destination projector setting] > [Confirm] and check the number assigned to each projector. 2 4 3 • If the projector is turned off and then on again during projection, the slideshow automatically resumes from the first image in the folder last used for projection. • If the image does not switch to the image for the corresponding number, adjust the IP address setting. 160
![](/manual_guide/products/canon-realis-lcos-wux500st-wux500st-users-manual-354a4cc/160.png)
Advanced Projection
160
•
[Destination projector setting]
Specify Secondary projector IP addresses.
•
[Slideshow interval]
Specify the slideshow interval (5 seconds to 10 minutes).
•
[Animation effect]
Specify the transition to use for slideshows.
5
On the Primary projector, select [Input settings] > [PC-free multi
projection] > [Destination projector setting] > [Confirm] and check the
number assigned to each projector.
•
If the projector is turned off and then on again during projection, the slideshow
automatically resumes from the first image in the folder last used for projection.
•
If the image does not switch to the image for the corresponding number, adjust the IP
address setting.
2
3
4