Canon VB-M720F Network Camera VB-H43/VB-H630VE/VB-H630D/VB-H730F/VB-M42/VB-M62 - Page 72

Record] and (11) [E-mail Notification] will be executed according to their settings upon an OFF event. (8) [Ongoing ON Event Operation] Select the operation to be performed while a volume detection event is ongoing. This can be set when [ON Event Operation] is set to [Enable]. Select [Enable] to perform operations according to the (10) [Video Record] and (11) [E-mail Notification] settings during an ongoing volume detection event. (9) [Preset] If a preset is specified, the camera will orient automatically to the specified preset position when a volume detection event occurs. To use presets, it is necessary to set the presets with the Preset Setting Tool under Admin Tools (p. 106). If there is no need for additional camera operation, select [None]. (10)[Video Record] Specify the video record action. If [Enable] is selected, video will be transmitted to the destination selected in [Video Record Action] (p. 71) when a volume detection event occurs. (11)[E-mail Notification] Select the e-mail notification operation to be performed. If [Enable] is selected, e-mail notification is performed when a volume detection event occurs. To use this function, [Upload] > [E-mail Notification] must also be set (p. 68). (12)[External Device Output for ON Event] Select whether external device output (1 or 2) is active or inactive upon an ON event. Select [Disable] to disable external device output. (13)[External Device Output for OFF Event] Select whether external device output (1 or 2) is active or inactive upon an OFF event. Select [Disable] to disable external device output. Important • The volume detection function is temporarily disabled during audio file playback and audio transmission from the viewer. • For notes on use of volume detection, see "Safety Precautions" in "Precautions for Use of Built-In Camera Functions and Included Software" (p. 7). • When Admin Viewer/VB Viewer has camera control privileges, those camera control privileges are released if the camera is moved to a preset position, specified in the [Preset] settings, by a volume detection event operation. (1) [Operation Mode] Select the normal (inactive) circuit condition. When [Normally Open] is selected, the output terminals remain in the open state during normal operation, and the terminals close upon an active event and open upon an inactive event. When [Normally Close] is selected, the output terminals remain in the closed state during normal operation, and the terminals open upon an active event and close upon an inactive event. (2) [Active Output Format] Select [Pulse] or [Continuous] for the external device output format. (3) [Pulse Output Time (sec)] Enter the pulse output time in the range of 1 to 120 (sec.). This setting is available when [Active Output Format] is [Pulse]. Important When [Active Output Format] is set to [Pulse] and a timer is used, a single contact output is controlled when the timer starts. Note [Normally Open] means that the contacts are normally in the open state (that the circuit is non-conductive), and [Normally Close] means that the contacts are normally in the closed state (that the circuit is conductive). Normally Open Active Event 1 (Terminals close) Inactive Event Normally Close Inactive Event 0 (Terminals open) 1 (Terminals close) Active Event 0 (Terminals open) External Device Input External Device Output (1) [External Device Input Event] Set external device input events to [Disable] or [Enable]. 72