Cisco 6509E Supervisor Guide - Page 70

Required Tools Chapter 3 Installing Supervisor Engines Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 93 Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view directly with optical instruments. Statement 1051 Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94 Required Tools These tools are required to install a supervisor engine in the chassis: • Small flat-blade screwdriver • No. 2 Phillips screwdriver • Antistatic mat to support an unpackaged supervisor engine • Your own ESD-prevention equipment or the disposable grounding wrist strap included with the module Installing a Supervisor Engine This section describes how to safely install a supervisor engine. Caution To prevent ESD damage, handle the supervisor engine by the carrier edges only. To install a supervisor engine in the chassis, follow these steps: Step 1 Attach an ESD grounding strap to your wrist and to the ESD ground connector on the chassis or to a properly grounded bare metal surface. Note If you are unsure about the correct way to attach an ESD grounding strap, see the "Attaching Your ESD Grounding Strap" section on page C-1 for instructions. Step 2 Determine the correct slot for the supervisor engine. The supervisor engines must be installed in these slots: • Supervisor Engine 2 - Slots 1 and 2 for all chassis • Supervisor Engine 32 - Slots 1 and 2 for 3- and 4-slot chassis Catalyst 6500 Series Supervisor Engine Guide 3-2 OL-7397-03