Cisco 7609-S Software Configuration Guide - Page 676

Configuring PFC QoS Chapter 41 Configuring PFC QoS Verifying Class Map Configuration To verify class map configuration, perform this task: Step 1 Step 2 Command Router (config-cmap)# end Router# show class-map class_name Purpose Exits configuration mode. Verifies the configuration. This example shows how to create a class map named ipp5 and how to configure filtering to match traffic with IP precedence 5: Router# configure terminal Enter configuration commands, one per line. Router(config)# class-map ipp5 Router(config-cmap)# match ip precedence 5 Router(config-cmap)# end End with CNTL/Z. This example shows how to verify the configuration: Router# show class-map ipp5 Class Map match-all ipp5 (id 1) Match ip precedence 5 Configuring a Policy Map You can attach only one policy map to an interface. Policy maps can contain one or more policy map classes, each with different policy map commands. Configure a separate policy map class in the policy map for each type of traffic that an interface receives. Put all commands for each type of traffic in the same policy map class. PFC QoS does not attempt to apply commands from more than one policy map class to matched traffic. These sections describe policy map configuration: • Creating a Policy Map, page 41-74 • Policy Map Class Configuration Guidelines and Restrictions, page 41-75 • Creating a Policy Map Class and Configuring Filtering, page 41-75 • Configuring Policy Map Class Actions, page 41-75 Creating a Policy Map To create a policy map, perform this task: Command Router(config)# policy-map policy_name Router(config)# no policy-map policy_name Purpose Creates a policy map. Deletes the policy map. 41-74 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX OL-4266-08