Cisco 7609-S Software Configuration Guide - Page 853

Chapter 50 Configuring NetFlow Configuring NetFlow Table 50-4 Summary of PFC NetFlow commands Command show mls netflow {...} show mls netflow aggregation flowmask Purpose Displays NetFlow PFC information for unicast and multicast traffic. Displays the NetFlow aggregation flow mask. Note • When you configure NetFlow aggregation on the MSFC, it is enabled automatically on the PFC. • When you configure NetFlow for Layer 2 traffic on the MSFC, it is enabled automatically on the PFC. • When you configure multicast NetFlow on the MSFC, it is enabled automatically on the PFC. Multicast NetFLow is supported in Release 12.2(18)SXF and later releases. Enabling NetFlow on the PFC To enable NetFlow statistics collection on the PFC, perform this task: Command Router(config)# mls netflow Router(config)# no mls netflow Purpose Enables NetFlow on the PFC. Disables NetFlow on the PFC. This example shows how to disable NetFlow statistics collection on the PFC (the default setting is enabled): Router(config)# no mls netflow Setting the Minimum IP MLS Flow Mask You can set the minimum specificity of the flow mask for the NetFlow table on the PFC. The actual flow mask may be more specific than the level configured in the mls flow ip command, if other configured features need a more specific flow mask (see the "Flow Mask Conflicts" section on page 50-4). To set the minimum IP MLS flow mask, perform this task: Command Router(config)# mls flow ip {source | destination | destination-source | interface-destination-source | full | interface-full} Router(config)# no mls flow ip Purpose Sets the minimum IP MLS flow mask for the protocol. Reverts to the default IP MLS flow mask (null). This example shows how to set the minimum IP MLS flow mask: Router(config)# mls flow ip destination OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 50-7