Cisco ATA-186 Administration Guide - Page 107

Chapter 5 Parameters and Defaults Optional Feature Parameters Table 5-6 OpFlags Parameter Operational Features to Turn On or Off (continued) Bit Number Definition 10 Reserved. 11 If Bit 11=0,the Cisco ATA requests the device hostname from the DHCP server. If Bit 11=1, the Cisco ATA uses the device hostname that is specified in DHCP option 12. 12-27 Reserved. 28-31 To configure the Cisco ATA to prompt the user for the UIPassword when the user attempts to perform a factory reset or upgrade using the voice configuration menu, configure bits 28 to 31 with the value of 6. Any other value for these bits means that the Cisco ATA will not prompt the user for the UIPassword in these cases. VLANSetting Description This parameter is for firmware version 2.15 and 2.14ms, and above. Bitmap definitions are as follows for the VLANSetting parameter: • Bits 0-2-Specify VLAN CoS bit value (802.1P priority) for TCP packets. • Bits 3-5-Specify VLAN CoS bit value (802.1P priority) for UDP packets. • Bits 6-17-Reserved. • Bits 18-29-User-specified 802.1Q VLAN ID. • Bits 30-31-Reserved. Value Type Bitmap Default 0x0000002b Voice Configuration Menu Access Code 324 Optional Feature Parameters This section describes the following parameters, which are located in the wheat-colored portion of the Cisco ATA Web Configuration Page: • NPrintf, page 5-36 • TraceFlags, page 5-36 • RingOnOffTime, page 5-37 • IPDialPlan, page 5-38 OL-3410-01 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP) 5-35