Cisco ATA-186 Administration Guide - Page 97
CallerIdMethod, Description, Examples, Value Type
View all Cisco ATA-186 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Chapter 5 Parameters and Defaults Operating Parameters CallerIdMethod Description This 32-bit parameter specifies the signal format to use for both FXS ports for generating Caller ID format. Possible values are: • Bits 0-1 (method)-0=Bellcore (FSK), 1=DTMF, values 2 and 3 are reserved. If method=0, set the following bits: • Bit 2-Reserved. • Bit 3 to 8-Maximum number of digits in phone number (valid values are 1 to 20; default is 12) • Bit 9 to 14-Maximum number of characters in name (valid values are 1 to 20; default is 15) • Bit 15-If this bit is enabled (it is by default), send special character O (out of area) to CID device if the phone number is unknown. • Bit 16-If this bit is enabled (it is by default), send special character P (private) to CID device if the phone number is restricted. • Bits 17 to 27-Reserved. If method=1, set the following bits: • Bits 3-6-Start digit for known numbers (valid values are 12 for "A," 13 for "B," 14 for "C," and 15 for "D.") • Bits 7-10-End digit for known numbers (valid values are 11 for "#," 12 for "A," 13 for "B," 14 for "C," and 15 for "D.") • Bits 11-Polarity reversal before and after Caller ID signal (value of 0/1 disables/enables polarity reversal) • Bits 12-16-Maximum number of digits in phone number (valid values are 1 to 20) • Bits 17 to 19-Start digit for unknown or restricted numbers (valid values are 4 for "A," 5 for "B," 6 for "C," and 7 for "D.") • Bits 20 to 22-End digit for unknown or restricted numbers (valid values are 3 for "#," 4 for "A," 5 for "B," 6 for "C," and 7 for "D.") • Bits 23 to 24-Code to send to the CID device if the number is unknown (valid values are 0 for "00," 1 for "0000000000," and 2 for "2." 3 is reserved and should not be used. • Bits 25 to 26-Code to send to the CID device if the number is restricted (valid values are 0 for "10," and 1 for "1." 2 and 3 are reserved and should not be used. • Bits 27 to 31-Reserved. Examples The following examples are recommended values for the CallerID Method parameter: • USA=0x19e60 • Sweden=0x0ff61 or 0x006aff61 • Denmark=0x0fde1 or 0x033efde1 Value Type Bitmap OL-3410-01 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP) 5-25