Cisco ATA-186 Administration Guide - Page 96
PaidFeatures
View all Cisco ATA-186 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Operating Parameters Chapter 5 Parameters and Defaults PaidFeatures Description Unsubscribe/subscribe to CallFeatures by setting each corresponding bit to either 0 or 1. The lower 16 bits are for the Phone 1 port, and the upper 16 bits are for the Phone 2 port. Table 5-3 provides definitions of each bit. Value Type Bitmap Default 0xffffffff Voice Configuration Menu Access Code 315 Table 5-3 PaidFeatures Parameter Bit Definitions Bit Number 0 1 2 3 4 5 6 7 8 9 10 11 15 Definition Forward unconditionally Forward on busy Forward on no answer CLIP_CLIR Call waiting three-way calling Blind transfer Transfer with consultation. This service allows the user to transfer the remote party to a different number by first calling that number and consulting with the callee. Caller ID. This service enables the Cisco ATA 186 to generate a Caller ID signal to drive a Caller ID display device attached to the FXS line. Call return Message waiting indication Call Waiting Caller ID. This is available only if the Method bit in CallerIdMethod is set to Bellcore (FSK). Fax mode. This service allows the user to set the Cisco ATA to Fax mode on a per-call basis. For Fax mode, use the following settings: • G.711 codec only • No silence suppression • No FAX tone detection 5-24 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP) OL-3410-01