Cisco CP-7942G Administration Guide - Page 64
Configuring Startup Network Settings
View all Cisco CP-7942G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Configuring Startup Network Settings Chapter 3 Setting Up the Cisco Unified IP Phone - Speaker 2. Some or all of the line keys flash amber in sequence. Caution If the line keys flash red in sequence after flashing amber, do not power down the phone until the sequence of red flashes completes. This sequence can take several minutes to complete. 3. Some or all of the line keys flash green. Normally, this sequence takes just a few seconds. However, if the phone's Flash memory is erased or the phone load is corrupted, the sequence of green flashes will continue while the phone begins a software update procedure. If the phone performs this procedure, the following buttons light to indicate progress: - Headset-Phone is waiting for the network and completing CDP and DHCP configuration. (A DHCP server must be available in your network.) - Mute-Phone is downloading images from the TFTP server. - Speaker-Phone is writing images to its Flash memory. 4. The LCD screen displays the Cisco Systems, Inc., logo screen. 5. These messages appear as the phone starts: - Verifying Load (if the phone load does not match the load on the TFTP server). If this message appears, the phone starts up again and repeats step 1 through step 4 above. - Configuring IP - Updating CTL - Updating Locale - Configuring Unified CM List - Registering 6. The main LCD screen displays: - Current date and time - Primary directory number - Additional directory numbers and speed dial numbers, if configured - Softkeys If the phone successfully passes through these stages, it has started up properly. If the phone does not start up properly, see the "Resolving Startup Problems" section on page 9-1. Configuring Startup Network Settings If you are not using DHCP in your network, you must configure these network settings on the Cisco Unified IP Phone after installing the phone on the network: • IP address • IP subnet information) • Default gateway IP address • TFTP server IP address 3-12 Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0 OL-15483-01