Cisco SPA509G Administration Guide - Page 131

Configuring SIP, SPCP, and NAT Network Address Translation (NAT) and Cisco IP Phones 4 • Handle VIA received, Insert VIA received, Substitute VIA Addr: yes • Handle VIA rport, Insert VIA rport, Send Resp To Src Port: yes • EXT IP: Enter the public IP address for your router. STEP 4 Click the Ext tab. Configure the following: • NAT Mapping Enable: Choose yes. • NAT Keep Alive Enable: Choose yes (optional). STEP 5 Click Submit All Changes. NOTE You also need to configure the firewall settings on your router to allow SIP traffic. See "Configuring SIP," on page 105. Configuring NAT Mapping with STUN If the ITSP network does not provide a Session Border Controller functionality, and if other requirements are met, it is possible to use STUN as a mechanism to discover the NAT mapping. This option is considered a practice of last resort and should be used only if the other methods are unavailable. Requirements • STUN is a viable option only if your router uses asymmetric NAT. See "Determining Whether the Router Uses Symmetric or Asymmetric NAT," on page 131. • You must have a computer running STUN server software. You can use a public STUN server or set up your own STUN server. NOTE Use NAT mapping only if the ITSP network does not provide a Session Border Controller functionality. STEP 1 Log in to the configuration utility. STEP 2 Click Admin Login and advanced. STEP 3 Click the SIP tab. STEP 4 Under NAT Support Parameters, configure the following: • Handle VIA received: yes • Handle VIA rport: yes Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 130