Cisco WS-C3560E-24PD-E Command Reference - Page 140
errdisable detect cause
View all Cisco WS-C3560E-24PD-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
errdisable detect cause Chapter 2 Catalyst 3560 Switch Cisco IOS Commands errdisable detect cause Use the errdisable detect cause global configuration command to enable error-disabled detection for a specific cause or all causes. Use the no form of this command to disable the error-disabled detection feature. errdisable detect cause {all | arp-inspection | dhcp-rate-limit | dtp-flap | gbic-invalid | l2ptguard | link-flap | loopback | pagp-flap} no errdisable detect cause {all | arp-inspection | dhcp-rate-limit | dtp-flap | gbic-invalid | l2ptguard | link-flap | pagp-flap} Syntax Description all arp-inspection dhcp-rate-limit dtp-flap gbic-invalid l2ptguard link-flap loopback pagp-flap Enable error detection for all error-disabled causes. Enable error detection for dynamic Address Resolution Protocol (ARP) inspection. Enable error detection for DHCP snooping. Enable error detection for the Dynamic Trunking Protocol (DTP) flapping. Enable error detection for an invalid Gigabit Interface Converter (GBIC) module. Note On the Catalyst 3560 switch, this error refers to an invalid small form-factor pluggable (SFP) module. Enable error detection for a Layer 2 protocol-tunnel error-disabled cause. Enable error detection for link-state flapping. Enable error detection for detected loopbacks. Enable error detection for the Port Aggregation Protocol (PAgP) flap error-disabled cause. Command Default Detection is enabled for all causes. Command Modes Global configuration Command History Release 12.1(19)EA1 12.2(20)SE 12.2(25)SE Modification This command was introduced. The arp-inspection keyword was added. The l2ptguard keyword was added. 2-108 Catalyst 3560 Switch Command Reference 78-16405-05