Cisco WS-C3560E-24PD-E Command Reference - Page 251
mac address-table static
View all Cisco WS-C3560E-24PD-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands mac address-table static mac address-table static Use the mac address-table static global configuration command to add static addresses to the MAC address table. Use the no form of this command to remove static entries from the table. mac address-table static mac-addr vlan vlan-id interface interface-id no mac address-table static mac-addr vlan vlan-id [interface interface-id] Syntax Description mac-addr vlan vlan-id interface interface-id Destination MAC address (unicast or multicast) to add to the address table. Packets with this destination address received in the specified VLAN are forwarded to the specified interface. Specify the VLAN for which the packet with the specified MAC address is received. The range is 1 to 4094. Interface to which the received packet is forwarded. Valid interfaces include physical ports and port channels. Defaults No static addresses are configured. Command Modes Global configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Examples This example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When a packet is received in VLAN 4 with this MAC address as its destination, the packet is forwarded to the specified interface: Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface gigabitethernet0/1 You can verify your setting by entering the show mac address-table privileged EXEC command. Related Commands Command Description show mac address-table static Displays static MAC address table entries only. 78-16405-05 Catalyst 3560 Switch Command Reference 2-219