Cisco WS-C3560E-24PD-E Command Reference - Page 472
show ipv6 access-list, sdm prefer, dual-ipv4-and-ipv6, default
View all Cisco WS-C3560E-24PD-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 472 highlights
show ipv6 access-list Chapter 2 Catalyst 3560 Switch Cisco IOS Commands show ipv6 access-list Use the show ipv6 access-list user EXEC command to display the contents of all current IPv6 access lists. show ipv6 access-list [access-list-name] Note This command is available only if the switch is running the advanced IP services image and you have configured a dual IPv4 and IPv6 Switch Database Management (SDM) template on the switch. Syntax Description access-list-name (Optional) Name of access list. Command Modes User EXEC Command History Release 12.2(25)SED Modification This command was introduced. Usage Guidelines The show ipv6 access-list command provides output similar to the show ip access-list command, except that it is IPv6-specific. To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan) global configuration command and reload the switch. Examples The following output from the show ipv6 access-list command shows IPv6 access lists named inbound and outbound: Router# show ipv6 access-list IPv6 access list inbound permit tcp any any eq bgp (8 matches) sequence 10 permit tcp any any eq telnet (15 matches) sequence 20 permit udp any any sequence 30 Table 2-26 describes the significant fields shown in the display. Table 2-26 show ipv6 access-list Field Descriptions Field IPv6 access list inbound permit tcp any Description Name of the IPv6 access list, for example, inbound. Permits any packet that matches the specified protocol type. Transmission Control Protocol. The higher-level (Layer 4) protocol type that the packet must match. Equal to ::/0. 2-440 Catalyst 3560 Switch Command Reference 78-16405-05