Cisco WS-C3560E-24PD-E Command Reference - Page 653
show interfaces, switchport mode, switchport
View all Cisco WS-C3560E-24PD-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 653 highlights
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands switchport access These restrictions apply to dynamic-access ports: • The software implements the VLAN Query Protocol (VQP) client, which can query a VMPS such as a Catalyst 6000 series switch. The Catalyst 3560 switches are not VMPS servers. The VMPS server must be configured before a port is configured as dynamic. • Use dynamic-access ports only to connect end stations. Connecting them to switches or routers (that use bridging protocols) can cause a loss of connectivity. • Configure the network so that STP does not put the dynamic-access port into an STP blocking state. The Port Fast feature is automatically enabled on dynamic-access ports. • Dynamic-access ports can only be in one VLAN and do not use VLAN tagging. • Dynamic-access ports cannot be configured as - Members of an EtherChannel port group (dynamic-access ports cannot be grouped with any other port, including other dynamic ports). - Source or destination ports in a static address entry. - Monitor ports. Examples This example shows how to change a switched port interface that is operating in access mode to operate in VLAN 2 instead of the default VLAN: Switch(config-if)# switchport access vlan 2 You can verify your setting by entering the show interfaces interface-id switchport privileged EXEC command and examining information in the Administrative Mode and Operational Mode rows. Related Commands Command show interfaces switchport switchport mode Description Displays the administrative and operational status of a switching (nonrouting) port, including port blocking and port protection settings. Configures the VLAN membership mode of a port. 78-16405-05 Catalyst 3560 Switch Command Reference 2-621