Cisco WS-SUP32-GE-3B Software Configuration Guide - Page 105

Chapter 6 Configuring RPR Supervisor Engine Redundancy Copying Files to the Redundant Supervisor Engine Command Step 4 Router# hw-module {module num} reset Step 5 Router# redundancy force-switchover Purpose Reloads the redundant supervisor engine and brings it back online (running the new version of the Cisco IOS software). Note Before reloading the redundant supervisor engine, make sure you wait long enough to ensure that all configuration synchronization changes have completed. Conducts a manual switchover to the redundant supervisor engine. The redundant supervisor engine becomes the new active supervisor engine running the new Cisco IOS image. The modules are reloaded and the module software is downloaded from the new active supervisor engine. The old active supervisor engine reboots with the new image and becomes the redundant supervisor engine. Note To perform an EHSA to RPR FSU, use the reload command in Step 5. This example shows how to perform an FSU: Router# config terminal Router(config)# config-register 0x2102 Router(config)# boot system flash disk0:image_name Router# copy running-config start-config Router# hw-module reset Router# redundancy force-switchover Router# Copying Files to the Redundant Supervisor Engine Use the following command to copy a file to the disk0: device on a redundant supervisor engine: Router# copy source_device:source_filename slavedisk0:target_filename Use the following command to copy a file to the bootdisk: device on a redundant supervisor engine: Router# copy source_device:source_filename slavesup-bootdisk:target_filename Use the following command to copy a file to the bootdisk: device on a redundant PISA: Router# copy source_device:source_filename slavebootdisk:target_filename OL-11439-03 Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY 6-7