Cisco WS-SUP32-GE-3B Software Configuration Guide - Page 700

Understanding NAC Chapter 41 Configuring Network Admission Control Retransmission Timer The retransmission timer controls the amount of time that the switch waits for a response from the client before resending a request during posture validation. Setting the timer value too low might cause unnecessary transmissions, and setting the timer value too high might cause poor response times. The default value of the retransmission timer is 3 seconds. Revalidation Timer The revalidation timer controls the amount of time that a NAC policy is applied to a client that used EAPoUDP messages during posture validation. The timer starts after the initial posture validation is complete. The timer resets when the host is revalidated. The default value of the revalidation timer is 36000 seconds (10 hours). You can specify the revalidation timer value on the switch by using the eou timeout revalidation seconds global configuration command. You can also specify the revalidation timer value on an interface by using the eou timeout revalidation seconds interface configuration command. Note The revalidation timer can be configured locally on the switch or it can be downloaded from the control server. The revalidation timer operation is based on Session-Timeout RADIUS attribute (Attribute[27]) and the Termination-Action RADIUS attribute (Attribute[29]) in the Access-Accept message from the Cisco Secure ACS running AAA. If the switch gets the Session-Timeout value, this value overrides the revalidation timer value on the switch. If the revalidation timer expires, the switch action depends on one of these values of the Termination-Action attribute: • If the value of the Termination-Action RADIUS attribute is the default, the session ends. • If the switch gets a value for the Termination-Action attribute other than the default, the EAPoUDP session and the current access policy remain in effect during posture revalidation. • If the value of the Termination-Action attribute is RADIUS, the switch revalidates the client. • If the packet from the server does not include the Termination-Action attribute, the EAPoUDP session ends. Status-Query Timer The status-query timer controls the amount of time the switch waits before verifying that the previously validated client is present and that its posture has not changed. Only clients that were authenticated with EAPoUDP messages use this timer, which starts after the client is initially validated. The default value of the status-query timer is 300 seconds (5 minutes). The timer resets when the host is reauthenticated. When the timer expires, the switch checks the host posture validation by sending a Status-Query message to the host. If the host sends a message to the switch that the posture has changed, the switch revalidates the posture of the host. NAC Layer 2 IP Validation and Redundant Supervisor Engines On Catalyst 6500 series switches with redundant supervisor engines, when RPR mode redundancy is configured, a switchover causes the loss of all information about currently postured hosts. When SSO mode redundancy is configured, a switchover triggers a reposturing of all currently postured hosts. 41-10 Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY OL-11439-03