Cisco WS-SUP32-GE-3B Software Configuration Guide - Page 89

Chapter 5 Configuring NSF with SSO Supervisor Engine Redundancy NSF Configuration Tasks Configuring SSO You must configure SSO in order to use NSF with any supported protocol. To configure SSO, perform this task: Step 1 Step 2 Command Router(config)# redundancy Router(config-red)# mode sso Step 3 Router# show running-config Step 4 Router# show redundancy states Purpose Enters redundancy configuration mode. Configures SSO. When this command is entered, the redundant supervisor engine is reloaded and begins to work in SSO mode. Verifies that SSO is enabled. Displays the operating redundancy mode. This example shows how to configure the system for SSO and display the redundancy state: Router> enable Router# configure terminal Enter configuration commands, one per line. Router(config)# redundancy Router(config-red)# mode sso Router(config-red)# end Router# show redundancy states my state = 13 -ACTIVE peer state = 8 -STANDBY HOT Mode = Duplex Unit = Primary Unit ID = 5 End with CNTL/Z. Redundancy Mode (Operational) = sso Redundancy Mode (Configured) = sso Split Mode = Disabled Manual Swact = Enabled Communications = Up client count = 29 client_notification_TMR = 30000 milliseconds keep_alive TMR = 9000 milliseconds keep_alive count = 1 keep_alive threshold = 18 RF debug mask = 0x0 Router# Configuring Multicast MLS NSF with SSO Note The commands in this section are optional and can be used to customize your configuration. For most users, the default settings are adequate. Multicast MLS NSF with SSO is on by default when SSO is selected as the redundancy mode. To configure multicast NSF with SSO parameters, perform this task: OL-11439-03 Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY 5-11