Coby DVD 925 Instruction Manual - Page 11

compartment

Page 11 highlights

• i7f -ush down and out on the battery Compartment cover to remove it. 2 Insert the two "AAA" batteries into the battery compartment of the remote control, making sure the + and - signs on the batteries and inside the battery compartment match up. 3. Replace the battery compartment cover. Do not mix batteries from different manufacturers, nor old ones with new. If the remote control will not be used for an extended period of time, remove the batteries- to prevent damage-causing corrosion. - Remove dead batteries immediately to prevent damage-causing corrosion. , If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace both batteries. Always replace both batteries at the same time, using new, fully charged batteries. Life expectancy of batteries may vary depending on amount of use. Notes: • Do not direct the remote sensor toward any light source, such as direct sunlight or a strong fluorescent light, as it may cause the unit to not operate Correctly. • When other remote controls are used nearby or when the remote is used near equipment using infrared rays, interference may occur. • Placing an object on the remote control may cause it to inadvertently depress a button, changing a function and shortening battery life. • Do not glaze the front of the DVD receiver with colored glass, as it may cause interference with normal operation of the controller. • Make sure there is no barrier between the remote control and remote sensor, as could prevent the unit from receiving the signal. • Do not spill water or put wet items on the remote control. • Never disassemble remote control. the Remote Control Point the remote control at the remote sensor on the DVD receiver. When the signal is received from the remote control, the unit will `. . 'iction accordingly. The remote will operate to approximately 16' from the remote sensor at an angle of around 30 each direction. BATTERIES INCORRECT USE OF BATTERIES MAY CAUSE THEM TO LEAK, CORRODE OR E;;P LODE.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31

i7f
-ush
down
and
out
on
the
battery
Compart-
ment
cover
to
remove
it.
2
Insert
the
two
"AAA"
batteries
into
the
battery
compartment
of
the
remote
control,
making
sure
the
+
and
-
signs
on
the
batteries
and
inside
the
battery
compartment
match
up.
3.
Replace
the
battery
compartment
cover.
Do
not
mix
batteries
from
different
manu-
facturers,
nor
old
ones
with
new.
If
the
remote
control
will
not
be
used
for
an
extended
period
of
time,
remove
the
batteries-
to
prevent
damage
-causing
corrosion.
-
Remove
dead
batteries
immediately
to
prevent
damage
-causing
corrosion.
,
If
battery
leakage
occurs,
wipe
the
battery
liquid
from
the
battery
compartment,
then
replace
both
batteries.
Always
replace
both
batteries
at
the
same
time,
using
new,
fully
charged
batteries.
Life
expectancy
of
batteries
may
vary
depending
on
amount
of
use.
the
Remote
Control
Point
the
remote
control
at
the
remote
sensor
on
the
DVD
receiver.
When
the
signal
is
received
from
the
remote
control,
the
unit
wi
ll
`.
.
'iction
accordingly.
The
remote
will
operate
to
approximately
16'
from
the
remote
sensor
at
an
angle
of
around
30
each
direction.
Notes:
Do
not
direct
the
remote
sensor
toward
any
light
source,
such
as
direct
sunlight
or
a
strong
fluorescent
light,
as
it
may
cause
the
unit
to
not
operate
Correctly.
When
other
remote
controls
are
used
nearby
or
when
the
remote
is
used
near
equipment
using
infrared
rays,
interference
may
occur.
Placing
an
object
on
the
remote
control
may
cause
it
to
inadvertently
depress
a
button,
changing
a
function
and
shortening
battery
life.
Do
not
glaze
the
front
of
the
DVD
receiver
with
colored
glass,
as
it
may
cause
interference
with
normal
operation
of
the
controller.
Make
sure
there
is
no
barrier
between
the
remote
control
and
remote
sensor,
as
could
prevent
the
unit
from
receiving
the
signal.
Do
not
spill
water
or
put
wet
items
on
the
remote
control
.
Never
disassemble
remote
control
.
BATTERIES
INCORRECT
USE
OF
BATTERIES
MAY
CAUSE
THEM
TO
LEAK,
CORRODE
OR
E;;P
LODE.