Compaq ProLiant 1200 ProLiant Server Troubleshooting Guide - Page 127
Attended Recovery, Hardware Requirements
View all Compaq ProLiant 1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Error Recovery Attended Recovery For attended recovery, ASR-2 executes the following functions: NOTE: This feature is only available on servers that use the System Configuration Utility. Attended recovery is not available on systems that use RBSU. • Logs the error information to the IML • Resets the server • Initiates Diagnostics from the hard drive • Enables remote access: - If you have configured for dial-in access and have a modem with an auto-answer feature installed, you can dial in and remotely diagnose or reconfigure the server. - If you have configured the Diagnostics for network access, you can access the utilities over the network. Use Insight Manager for either dial-in or network access. Hardware Requirements To obtain full utilization of ASR-2 over a modem, you need the following: • A non-PCI Hayes-compatible modem • Diagnostics installed on the system partition of the hard drive • ASR-2 configured to load Diagnostics after restart You can also run Diagnostics remotely over an Internetwork Packet Exchange (IPX) or Internet Protocol (IP) network using the Network feature. • To use Diagnostics on an IPX network, you must have Insight Manager 2.0 or later, or a Novell Virtual Terminal (NVT) terminal emulator with VT100 or American National Standards Institute (ANSI) terminal capabilities. • To use Diagnostics on an IP network, you must have Insight Manager 2.10 or later, or a Telnet terminal emulator with VT100 or ANSI capabilities. 5-6 HP Servers Troubleshooting Guide