Compaq ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 91
Reseat the Server Feature
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Diagnostic Tools 3-13 Table 3-2 POST Error Messages continued Error Code Audible Beeps 800-Server Feature None Board must be installed in slot 1 for proper operation 801-Server Feature None Board is not properly cabled to the system. Verify that the server management information cable from the system board to the Server Feature Board in slot 1 is intact and fully seated at both ends. 802-Processor X is None missing or terminator board is not present. System Halted. Probable Source of Problem The system has detected the absence of the Server Feature Board. The system has detected that the server management information cable is not properly installed. The system detected that the indicated processor is empty. Recommended Action 1. Install the Server Feature Board in PCI slot 1. 2. Reseat the Server Feature Board. 3. Verify that the Server Feature Board is from this system. 1. Check to make sure that a server management information cable is installed in the system. 2. Inspect the server management information cable for signs of damage. 3. Reseat the server management information cable on the system board and on the Server Feature Board. 1. Verify that a processor or processor terminator card is installed in each processor slot. 2. Reseat the processor or processor terminator card in each processor slot. 3. Verify that each processor has a corresponding Processor Power Module installed. 4. Try replacing each processor with a processor terminator card to detect a failed processor or Processor Power Module. continued