Compaq ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 96
S.M.A.R.T., Hard Drives Detect
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
3-18 Compaq ProLiant 8500 Server Maintenance and Service Guide Table 3-2 POST Error Messages continued Error Code Audible Beeps 1720-Slot X Drive None Array - S.M.A.R.T. Hard Drive(s) Detect Imminent Failure SCSI: Port Y: SCSI ID Z. 1721-Slot X Drive None Array - Drive parameter tracking predicts imminent failure. The following devices should be replaced when conditions permit. Do not replace drive unless all other drives in the array are on-line! Back up data before replacing drive(s) if using RAID 0. 1721- SMART SCSI None Hard Drive detects imminent failure 1724-Slot X Drive None Array - Physical Drive Position Change(s) Detected - Logical drive configuration has automatically been updated. RESUME = F1 KEY Probable Source of Problem Hard drive predictive failure condition detected. Monitor and Performance thresholds exceeded condition. Indicated drive has reported a SMART predictive-failure condition and may fail at some time in the future. Drive change detected. Recommended Action The indicated drive has reported a SMART predictive failure condition. It may fail at some time in the future. If this drive is part of a non-fault-tolerant configuration, back up all data before replacing the drive and restore all data afterward. If this drive is part of a fault-tolerant configuration, do not replace this drive unless all other drives in the array are online. Press F1 key to resume. Replace the drive when it is reasonable for you to do so. The drive has not failed, but Compaq recommends you replace the drive. If this drive is part of a non-fault tolerant configuration, back up all data before replacing the drive, and restore all data afterward. -OrIf this drive is part of a fault tolerant configuration, do not replace this drive unless all other drives in the array are online. Press F1 key to resume. This message indicates that logical drive configuration has been updated automatically following physical drive position changes. Press F1 key to resume. continued