Cub Cadet LTX 1045 Operation Manual - Page 88
Position, Start,
View all Cub Cadet LTX 1045 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
DrivingTheTractor and sudden stops. i_lk WARNING! Avoid sudden starts, excessive speed 1. Lightly press the brake pedal to release the parking brake. Move the throttle lever into the FAST (rabbit) position. 2. To travel FORWARD, slowly press the drive pedal forward until the desired speed is achieved. See Fig. 5-1. / Pedal ReverseCaution Mode The REVERSE CAUTION MODE position of the key switch module allows the tractor to be operated in reverse with the blades (PTO) engaged. NOTE: Mowing in reverse is not recommended. the tractor in the REVERSECAUTION MODE. Always WlooAkRNdoINwGn! anUdsbeeehxintrdembeefocraeutaionnd wwhhiillee obpaecrkaintign.g Do not operate the tractor when children or others are around. Stop the tractor immediately if someone enters the area. To use the REVERSECAUTION MODE: NOTE:The operator MUST be seated in the tractor seat. 1. Start the engine as previously instructed on the previous page. 2. Turn the key from the NORMAL MOWING (Green) position to the REVERSECAUTION MODE (Yellow) position of the key switch module. See Fig. 5-2. F Reverse Stop Position PusRhevBeurtstoen Caution Mode Position 3. To travel in REVERSE, check that the area behind is clear then slowly depress the reverse pedal with the ball of your foot (NOTyour heel) until the desired speed is achieved. See Fig. 5-1. Position Start CAUTION: Do NOT attempt to change the direction of travel when the tractor is in motion. Always bring the tractor to a complete stop before moving from forward to reverse or vice versa. J WARNING! Do not leave the seat of the tractor Figure 5=2 without first placing the PTO/Blade Engage lever in the disengaged (OFF) position and engaging the 3. Press the REVERSE PUSH BUTTON (Orange, Triangular parking brake. If leaving the tractor unattended, also Button) at the top, right corner of the key switch module. turn the engine offand remove the ignition key. The red indicator light at the top, left corner of the key switch module will be ON while activated. See Fig. 5-2. 4. Once activated (indicator light ON), the tractor can be driven in reverse with the cutting blades (PTO) engaged. 5. Always look down and behind before and while backing to make sure no children are around. After resuming forward motion, return the key to the NORMAL MOWING position. The REVERSE CAUTION MODE will remain activated until: a. The key is placed in either the NORMAL MOWING position or STOP position or b. The operator leaves the seat. SECTION S-- OPERATION