D-Link DES-3828 Product Manual - Page 162

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual Example usage: To create an access profile based on IPv6 classification: DES-3800:admin# create access_profile ipv6 class flowlabel profile_id 4 Command: create access_profile ipv6 class flowlabel profile_id 4 Success. DES-3800:admin# config access_profile profile_id (ipv6) Purpose Syntax Description Parameters Used to configure the IPv6 access profile on the Switch and to define specific values for the rules that will be used to by the Switch to determine if a given packet should be forwarded, filtered or mirrored. Masks entered using the create access_profile command will be combined, using a logical AND operational method, with the values the Switch finds in the specified frame header fields. config access_profile profile_id [add access_id ] ipv6 {class | flowlabel | source_ipv6 | destionation_ipv6 } port [permit {priority {replace_priority}} | deny] | delete ] This command is used to define the rules used by the Switch to either filter, forward or mirror packets based on the IPv6 part of each packet header. profile_id - Enter an integer between 1 and 8 that is used to identify the access profile that will be configured with this command. This value is assigned to the access profile when it is created with the create access_profile command. The lower the profile ID, the higher the priority the rule will be given. add access_id - Adds an additional rule to the above specified access profile. The value specifies the relative priority of the additional rule. Up to 65535 different rules may be configured for the IPv6 access profile. ipv6 - Specifies that the Switch will look into the IPv6 fields in each packet, with emphasis on one or more of the following fields: • class - Entering this parameter will instruct the Switch to examine the class field of the IPv6 header. This class field is a part of the packet header that is similar to the Type of Service (ToS) or Precedence bits field in IPv4. • flowlabel - Entering this parameter will instruct the Switch to examine the flow label field of the IPv6 header. This flow label field is used by a source to label sequences of packets such as non-default quality of service or real time service packets. This field is to be defined by the user in hex form. • source_ipv6 - Specifies an IP address mask for the source IPv6 address. • destination_ipv6 - Specifies an IP address mask for the destination IPv6 address. port - The access profile for Ethernet may be defined for each port on the Switch. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are 158