D-Link DES-3828 Product Manual - Page 411

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual config dhcp pool netbios_node_type Purpose Syntax Description Parameters Restrictions Specifies the NetBIOS node type for a Microsoft DHCP client. config dhcp pool netbios_node_type [broadcast | peer_to_peer | mixed | hybid] The NetBIOS node type for Microsoft DHCP clients can be one of four settings: broadcast, peer-to-peer, mixed, or hybrid. Use this command to config NetBIOS over TCP/IP device that described in RFC 1001/1002. By default, NetBIOS node type is broadcast. - Pool's name. - NetBIOS node type for a Microsoft DHCP client. Only Administrator or Operator-level users can issue this command. Usage Example: To configure NetBIOS node type: DES-3800:admin# config dhcp pool netbios_node_type engineering hybid Command: config dhcp pool netbios_node_type engineering hybid Success. DES-3800:admin# config dhcp pool default_router Purpose Syntax Description Parameters Restrictions Specifies the IP address of the default router for a DHCP client. Up to three IP addresses can be specified in one command line. config dhcp pool default_router {< ipaddr>} {< ipaddr>} {< ipaddr>} After a DHCP client has booted, the client begins sending packets to its default router. The IP address of the default router should be on the same subnet as the client. If default_router is not specified , the default router information will not be provided to the client. If this command are input twice for the same pool, the second command will overwrite the first command. The default router must be ranged within the network defined for the DHCP pool. - Pool's name. - Ip address of default router. Only Administrator or Operator-level users can issue this command. 407