D-Link DES-3828 Product Manual - Page 63

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual download Restrictions specified. increment- Allows the download of a partial switch configuration file. This allows a file to be downloaded that will change only the switch parameters explicitly stated in the configuration file. All other switch parameters will remain unchanged. The TFTP server must be on the same IP subnet as the Switch. Only Administrator-level users can issue this command. Example usage: To download a configuration file: DES-3800:admin#download configuration 10.48.74.121 c:\cfg\setting.txt Command: download configuration 10.48.74.121 c:\cfg\setting.txt Connecting to server Done. Download configuration Done. DES-3800:admin# config firmware Purpose Used to configure the firmware section as a boot up section, or to delete the firmware section Syntax Description config firmware image_id [delete | boot_up] This command is used to configure the firmware section. The user may choose to remove the firmware section or use it as a boot up section. Parameters image_id - Specifies the working section. The Switch can hold two firmware versions for the user to select from, which are specified by image ID. - Select the ID number of the firmware in the Switch's memory to be configured. delete - Entering this parameter will delete the specified firmware section. boot_up - Entering this parameter will specify the firmware image ID as a boot up section. Restrictions Only Administrator-level users can issue this command. Example usage: To configure firmware image 1 as a boot up section: DES-3800:admin# config firmware image_id 1 boot_up Command: config firmware image_id 1 boot_up Success. DES-3800:admin# 59