D-Link DES-3828 Product Manual - Page 166

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual show current_config access_profile Purpose Syntax Description Parameters Restrictions Used to show the ACL CLI commands in current configuration. show current_config access_profile The ACL port will be displayed by this command. None. None. Example usage: To display ACL part: DES-3800:admin#show current_config access_profile Command: show current_config access_profile # ACL create access_profile ethernet vlan profile_id 1 config access_profile profile_id 1 add access_id 1 ethernet vlan default port 1 permit disable cpu_interface_filtering DES-3800:admin# config flow_meter Purpose To configure packet flow-based metering based on an access profile and rule. Syntax config flow_meter profile_id access_id rate rate_exceed [drop | set_drop_precedence] Description This command is used to configure the flow-based metering function, users may set the preferred bandwidth for this rule, in Kbps and once the bandwidth has been exceeded, overflow packets will be either dropped or be set for a drop precedence, depending on user configuration. The set_drop_precedence function work with WRED. Note: If the bandwidth is configured as zero, the meter will be destroyed. Parameters Profile_id - Specifies the profile_ID access_id - Specifies the access_ID Rate - Specify the committed bandwidth in Kbps for the flow. The value of 0 means to delete this flow_meter setting. rate_exceed - This specifies the action for packet which exceed the committed rate.The action can be specified to be one of the following. drop_packet: drop_packet. set_drop_precedence: the packet will not be dropped right away. However, when the traffic is busy, it has the higher probability to be dropped in the 162