D-Link DGS-3630 Emulator 1 - Page 10

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# enable Switch# configure terminal Switch(config)# username admin password admin Switch(config)# username admin privilege 15 Switch(config)# line console Switch(config-line)# login local Switch(config-line)# In the above example we had to navigate and access the username command. • Starting in the User EXEC Mode, we enter the enable command to access the Privileged EXEC Mode. • After accessing the Privileged EXEC Mode, we entered the configure terminal command to access the Global Configuration Mode. The username command can be used in the Global Configuration Mode. • The username admin password admin command creates a user account with the username of admin and a password of admin. • The username admin privilege 15 command assigns a privilege level value of 15 to the user account admin. • The line console command allows us to access the console interface's Line Configuration Mode. • The login local command tells the Switch that users need to enter locally configured login credentials to access the console interface. Save the running configuration to the start-up configuration. This means to save the changes made so that when the Switch is rebooted, the configuration will not be lost. The following example shows how to save the running configuration to the start-up configuration. Switch# copy running-config startup-config Destination filename startup-config? [y/n]: y Saving all configurations to NV-RAM.......... Done. Switch# After the Switch has rebooted, or after the users log out and back in, the newly created username and password must be entered to access the CLI interface again, as seen below. DGS-3630-28PC Gigabit Ethernet Switch Command Line Interface Firmware: Build 2.20.B007 Copyright(C) 2018 D-Link Corporation. All rights reserved. User Access Verification Username:admin Password:***** Switch# Interface Notation When configuring the physical ports available on this switch, a specific interface notation is used. The following will explain the layout, terminology and use of this notation. In the following example, we'll enter the Global Configuration Mode and then enter the Interface Configuration Mode, using the notation 1/0/1. After entering the Interface Configuration Mode for port 1, we'll change the speed to 1 Gbps, using the speed 1000 command. 5