D-Link DGS-3630 Emulator 1 - Page 371

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to display all the remote MEP information seen by local MEP 1. Switch#show cfm remote-mep mepid 1 ma name op1 domain op-domain Remote MEPID: 2 MAC Address: FF-FF-FF-FF-FF-FF Status: OK RDI: Yes Port State: Up Interface Status: No Last CCM Serial Number: 1000 Sender Chassis ID: None Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161 Detect Time: 2000-02-02 23:21:38 Remote MEPID: 3 MAC Address: 11-22-33-44-02-05 Status: OK RDI: Yes Port State: Up Interface Status: No Last CCM Serial Number: 200 Sender Chassis ID: None Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161 Detect Time: 2010-11-01 17:00:00 Switch# This example shows how to display the remote MEP information. Switch# show cfm remote-mep mepid 1 ma name op-ma domain op-domain remote-mepid 2 Remote MEPID: 2 MAC Address: FF-FF-FF-FF-FF-FF Status: OK RDI: Yes Port State: Up Interface Status: No Last CCM Serial Number: 1000 Sender Chassis ID: None Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161 Detect Time: 2000-02-02 23:21:38 Switch# Display Parameters Status RDI Port State Indicates the operational state of the Remote MEP state machine. IDLE: The momentary state during reset. START: The timer has not expired since the state machine was reset, and no valid. The CCM has yet been received. FAILED: The timer has expired since a valid CCM was received or since the state machine was reset. OK: A valid CCM was received before the timer expired. Indicates the state of the RDI bit in the last received CCM. Yes: The RDI bit was set. No: RDI bit was cleared or no valid CCM was received. The port state indicates the ability of the bridge port on which the remote MEP resides to pass ordinary data, regardless of the status of the MAC. None: Indicates either that no CCM has been received or that no port status TLV was present in the last CCM received. 366