D-Link DGS-3630 Emulator 1 - Page 1209

Parameters DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide announce interval SECONDS timeout VALUE sync-interval delay-req-interval VALUE pdelay-req-interval SECONDS delay-mechanism e2e p2p Specifies that the attributes for the announce message of PTP boundary port. Specifies the mean time interval between successive announce messages. In line with the IEEE 1588 protocol, the value of the announce interval is represented as the logarithm to the base 2 of this time measured in seconds. The value is from 1 to 16, and thus the imported value can be 1, 2, 4, 8, or 16. Specifies the announce interval number that has to pass without receiving an Announce message before the occurrence of the ANNOUNCE_RECEIPT_TIMEOUT_EXPIRES event. This value multiplied by the announce interval value is equal to the interval time of the announce receipt timeout. The range is from 2 to 10. Specifies the mean time interval between successive Sync messages. half-second - Specifies that the synchronization interval will be set to half a second. SECONDS - Specifies the synchronization interval value. This value is from 1 to 2. Specifies the permitted mean time interval between successive delay request messages which are sent by a slave to a specific port on the master. This mean time interval value is determined and advertised by a master. If the sync-interval parameter is half-second and the delay-req-interval parameter is 0, the permitted time interval between successive delay request messages will be automatically adjusted to one second. Specifies the permitted mean time interval between successive PDelay Request messages. In line with the IEEE 1588 protocol, the value of the announce interval is represented as the logarithm to the base 2 of this time measured in seconds. The value is from 1 to 32, and thus the imported value can be 1, 2, 4, 8, 16, or 32. Specifies the mechanism for measuring the propagation delay time of an event message. Specifies that the port is configured to use the delay request-response mechanism. Specifies that the port is configured to use the peer delay mechanism. Default By default, the value of the announce interval is 2 seconds. By default, the value of the interval time of the announce receipt timeout is 3. By default, the value of the Sync message interval is 1 second. By default, the value of the interval time of the delay request messages is 0. By default, the value of the PDelay Request message interval is 1 second. By default, the mechanism for measuring the propagation delay time is e2e. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the attributes of the PTP boundary clock on physical ports or port channel interfaces. This command takes effect when the PTP device is the boundary type. 1204