D-Link DGS-3630 Emulator 1 - Page 1654

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline Use this command to create a VPWS service and enter the Xconnect configuration mode. When creating the VPWS on a physical port or link aggregation group, the service is Ethernet-based and this Ethernet port or link aggregation group is the AC. When creating the VPWS on a VLAN sub-interface of a switch port interface, the service is Ethernet VLAN-based and this VLAN sub-interface of the Switch port is the AC. Use the no xconnect command to remove a VPWS service. The settings related to the service are also removed. Example This example shows how to configure the AC from the Customer Edge Bridge (CE) to the PE as the VLAN 10 of port 1. Assume the VC's ID is 2. For making the VLAN 10 packets from CE one can be transmitted to the other end through the MPLS network. Configure PE1 and PE2 as follows. Configuring PE 1: Switch# configure terminal Switch(config)# interface eth1/0/1 Switch(config-if)# service encapsulation svid 10 Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls Switch(config-if-xconn)# Configuring PE 2: Switch# configure terminal Switch(config)# interface eth1/0/1 Switch(config-if)# service encapsulation svid 10 Switch(config-if-srv)# xconnect 110.1.1.12 2 encapsulation mpls Switch(config-if-xconn)# 1649