D-Link DGS-3630 Emulator 1 - Page 1518

4-port DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies 4 switch ports to be used for stacking. Default By default, 2 ports are used. Command Mode Privileged EXEC Mode. Command Default Level Level: 12. Usage Guideline Use this command to change the stacking port bandwidth. The stacking bandwidth must be configured before the Switch is stacked with other switches. Physical stacking needs to be enabled and can be configured to support either a 2-port or a 4-port stacking configuration. When the 2-port stacking configuration is used, a full-duplex speed of up to 40Gbps will be used between two switches. • The DGS-3630-28TC will use physical ports 27 (SIO1) and 28 (SIO2) for 2-port stacking. • The DGS-3630-28SC will use physical ports 27 (SIO1) and 28 (SIO2) for 2-port stacking. • The DGS-3630-52TC will use physical ports 51 (SIO1) and 52 (SIO2) for 2-port stacking. When the 4-port stacking configuration is used, a full-duplex speed of up to 80Gbps will be used between two switches using four physical ports aggregated into two virtual stacking ports. • The DGS-3630-28TC will use physical ports 25 (SIO1), 26 (SIO2), 27 (SIO1), and 28 (SIO2) for 4-port stacking. • The DGS-3630-28SC will use physical ports 25 (SIO1), 26 (SIO2), 27 (SIO1), and 28 (SIO2) for 4-port stacking. • The DGS-3630-52TC will use physical ports 49 (SIO1), 50 (SIO2), 51 (SIO1), and 52 (SIO2) for 4-port stacking. SIO1 is a logical stacking port pair and SIO2 is a logical stacking port pair. A logical stacking port pair must always be connected to the same Switch in the stack. Splitting logical stacking port pairs between different Switches in the stack might not guarantee a stable stacking connection. Example This example shows how to change the stacking bandwidth to 4-port. Switch#stack bandwidth 4-port WARNING: The command does not take effect until the next reboot. Switch# 118-3 stack renumber This command is used to manually assign a unit ID to a switch unit. Use the no form of this command to set the unit ID of the switch to auto-assigned. stack CURRENT-UNIT-ID renumber NEW-UNIT-ID no stack CURRENT-UNIT-ID renumber 1513