D-Link DGS-3630 Emulator 1 - Page 253

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline The route redistribute to BGP has the origin code "INCOMPLETE". The main purpose of this command is to set origin code for the redistributed route. The origin code (ORIGIN) is a well-known mandatory attribute that indicates the origin of the prefix. The origin code has three values: • IGP, indicates that the prefix is originated from an Interior Gateway Protocol. • EGP, indicates that the prefix is originated from an Exterior Gateway Protocol. • INCOMPLETE, indicates that the prefix is originated from unknown source. You can verify your settings by entering the show route-map command. Example This example shows how to set the origin of routes that pass the AS path list, PATH_ACL in the route map, named myPolicy, to EGP. Switch# configure terminal Switch(config)# route-map myPolicy permit 1 Switch(config-route-map)# match as-path PATH_ACL Switch(config-route-map)# set origin egp Switch(config-route-map)# 13-82 set weight (MI and EI Mode Only) This command is used to set the BGP weight for the matched routes. Use the no form of this command to remove the command statement. set weight NUMBER no set weight Parameters NUMBER Specifies the weight for the matched routes. This value must be between 0 and 65535. Default There is no set weight statement. Command Mode Route-map Configuration Mode. Command Default Level Level: 12. Usage Guideline BGP weight is an attribute that is assigned by the local router to affect the best path selection on the local router among eBGP routes. The specified weight is associated with the inbound paths. The weight attribute will not be propagated with the route. Weight can be specified per neighbor session by the neighbor weight command. The routes received from this session will be associated with this weight. The weight can also be set in route map to associate the weight with the ingress route. When a route's weight is set by both the neighbor weight command and the set weight command, the setting set by the set weight command will override the setting set by the neighbor weight command. 248