D-Link DGS-3630 Emulator 1 - Page 1093

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline Use this command to change the OSPF network type of an interface. On a broadcast network, only the designated router and backup designated router become adjacent neighbors of all other routers attached. On point-to-point network, only two routers become adjacent if they can communicate. Example This example shows how to configure the OSPF network type to point-to-point on the VLAN 1 interface. Switch# configure terminal Switch(config)# interface vlan1 Switch(config-if)# ip ospf network point-to-point Switch(config-if)# 85-20 ip ospf priority This command is used to configure the router priority that is used to determine the designated router for the network. Use the no form of this command to revert to the default setting. ip ospf priority PRIORITY no ip ospf priority Parameters PRIORITY Specifies the priority of the router on the interface. This value must be between 0 and 255. Default By default, this value is 1. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The OSPF router will determine a designated router for the multi-access network. This command sets the priority used to determine the OSPF Designated Router (DR) for a network. If two routers attempt to become the DR, the router with the higher router priority will be elected the DR. If the routers have the same priority, the router with the higher router ID takes precedence. Only routers with non-zero router priority values are eligible to become the designated or backup designated router. 1088