Dell Alienware 13 R3 Service Manual - Page 83
Removing the camera cable, Prerequisites, Procedure
View all Dell Alienware 13 R3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Removing the camera cable WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Prerequisites NOTE: These instructions are applicable only for laptops with a nontouch screen display. 1 Remove the base cover. 2 Remove the wireless card. 3 Remove the solid-state drive. 4 Remove the memory modules. 5 Remove the rear-I/O cover. 6 Remove the computer base. 7 Remove the coin-cell battery. 8 Remove the heat-sink assembly. 9 Remove the battery. 10 Remove the system board. 11 Remove the display assembly. 12 Remove the display bezel. 13 Remove the display panel. 14 Remove the display hinges. Procedure 1 Peel the tape that secures the camera cable to the camera module and disconnect the camera cable from the camera module. 83