Dell Alienware x16 R2 Owners Manual - Page 104
Palm-rest and keyboard assembly
View all Dell Alienware x16 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Palm-rest and keyboard assembly Removing the palm-rest and keyboard assembly CAUTION: The information in this removal section is intended for authorized service technicians only. Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. 3. Remove the battery. 4. Remove the wireless card. 5. Remove the M.2 2230 solid state drive or M.2 2280 solid state drive, as applicable. 6. Remove the solid state drive bracket. 7. Remove the processor fan. 8. Remove the graphics-card fan. 9. Remove the rear I/O-cover. 10. Remove the power-adapter port. 11. Remove the headset port. 12. Remove the display assembly. 13. Remove the touchpad. 14. Remove the keyboard-controller board. 15. Follow the procedure from step 1 to step 16 in Removing the system board. NOTE: The system board can be removed and installed along with the heat sink. This simplifies the removal and installation procedure and avoids breaking the thermal bond between the system board and heat sink. 16. Remove the I/O board. 17. Remove the power button. Steps After performing the pre-requisites, you are left with the palm-rest and keyboard assembly. NOTE: The left and right tweeters are adhered to the palm-rest and keyboard assembly with strong adhesive and should not be removed. The replacement palm-rest and keyboard assembly will be shipped with the speakers. Install the speakers and tweeters to the new palm-rest and keyboard assembly. For installing the speakers and tweeters, see step 1 to step 5 in Installing the palm-rest and keyboard assembly. 104