Dell Alienware x16 R2 Owners Manual - Page 50
Installing the rear I/O-cover, the rear I/O cover.
![]() |
View all Dell Alienware x16 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Installing the rear I/O-cover Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following images indicate the location of the rear I/O-cover and provide a visual representation of the installation procedure. NOTE: To avoid damaging your computer, ensure that the Tron-light cable is not pinched when sliding the rear I/O-cover into the palm-rest and keyboard assembly. Steps 1. With the correct orientation, slide the rear I/O-cover into the palm-rest and keyboard assembly, and snap it into place. 2. Replace the four screws (M1.6x3) that secure the left and right Tron-light cables to the palm-rest and keyboard assembly. CAUTION: Do not pull at the bend points of the Tron-light cables and check for damage while removing and installing the rear I/O cover. 3. Replace the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest and keyboard assembly. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. 50
![](/manual_guide/products/dell-alienware-x16-r2-owners-manual-22e204b/50.png)