Dell Alienware x16 R2 Owners Manual - Page 67
Installing the keyboard-controller board
View all Dell Alienware x16 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Installing the keyboard-controller board CAUTION: The information in this installation section is intended for authorized service technicians only. Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following images indicate the location of the keyboard-controller board and provide a visual representation of the installation procedure. Steps 1. Using the alignment posts, place the keyboard-controller board into the slot on the palm-rest and keyboard assembly. 2. Replace the two screws (M1.6x1.6) that secure the keyboard-controller board to the palm-rest and keyboard assembly. 3. Slide the keyboard cable into the connector on the keyboard-controller board and close the latch to secure the cable. 4. Slide the touchpad cable into the connector on the keyboard-controller board and close the latch to secure the cable. 5. Slide the keyboard-controller board cable into the connector on the keyboard-controller board and close the latch to secure the cable. 67