Dell Axim X51 Owner's Manual - Page 98

Using Cisco® LEAP Wireless LAN Security Your Dell Axim X51/X51v supports 802.1x network authentication between the client and server with a logon password using Cisco LEAP. Cisco LEAP can be configured using the Odyssey Client application. NOTE: Before starting, ensure that the Wireless power is enabled using the Wireless On/Off button. NOTE: LEAP is not supported on a peer-to-peer network. LEAP is not supported on a low configuration Axim X51. To start Odyssey Client: 1 Tap Start → Settings → Connections → Odyssey Client icon. 2 Tap Settings → Enable Odyssey. To start using LEAP: 1 Obtain the following information from your network administrator: • Network name • Association mode • Encryption method 2 From the Odyssey Client window, tap Settings → Configure → Add. 3 Enter the network name (SSID) if known, or tap Scan to search for available Access Points. Tap Next. 4 LEAP will only support an infrastructure network, so do not change the default settings in the drop-down menu. Tap Next. 5 Fill in the Association Mode and Encryption method. Tap Next. 6 EAP/TTLS is the default EAP type. Tap Add and select EAP/LEAP in the window that opens up. Unless you have an authentication certificate to use TTLS and have configured your system to support it, remove EAP/TTLS. NOTE: Failure to remove EAP/TTLS when it is not properly set up may prevent your wireless security system from functioning. 7 Tap Next. 8 Enter your user name and password. Tap Next. 9 Tap Finish to complete LEAP configuration. 98 Getting Connected