Dell Force10 C300 Quick Start Guide - Page 13
C300 Power Entry Module Installation
View all Dell Force10 C300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
• To protect against high-voltage shock, install a power supply blank (CC-CBLNK-PWR) on all unused power supply slots. CAUTION: Some CH-C300 chassis may require Dell Force10 assistance when using some DC power supplies. Please contact the Dell Force10 TAC if you experience any difficulty during installation Step Task 1 Turn the remote power source (the circuit breaker panel) to the OFF position. 2 Turn the over-current switch (located on the PEM front panel) to the OFF position. 3 Loosen the PEM safety cover retaining screw and remove the cover. 4 Slide the PEM into slots 1 and 2 (for the C150) or slots 0 and (for the C300) NOTE: Fill all empty slots with blank panels. C150 Entry Module Installation Over-Current Switch Safety Cover Handle Retaining Latch BLNK fn003lp fn003lp fn00012lpp BLNK BLNK BLNK Power Supply Blank C300 Power Entry Module Installation fn0002lp Installing the Hardware 11