Dell Force10 C300 Quick Start Guide - Page 27

Con the Management Port IP Address, Con a Management Route - default password

Get Dell Force10 C300 PDF manuals and user guides View all Dell Force10 C300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

The C150 and C300 systems have a dedicated management port and a management routing table that is separate from the IP routing table. Configuring the system for Telnet is a three-step process: Step Task 1 Configure an IP address for the management port. 2 Configure a management route with a default gateway. 3 Configure a username and password. Configure the Management Port IP Address Assign IP addresses to the management ports in order to access the system remotely. NOTE: Assign different IP addresses to each RPM's management port. Step Task Command Syntax Command Mode 1 Enter INTERFACE interface ManagementEthernet CONFIGURATION mode for the slot/port Management port. 2 Assign an IPv4 or IPv6 address to the interface. ip address {ipv4-address | ipv6- INTERFACE address}/mask 3 Enable the interface. no shutdown INTERFACE Configure a Management Route Define a path from the system to the network from which you are accessing the system remotely. Management routes are separate from IP routes and are only used to manage the system through the management port. Installing the Software 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Installing the Software
25
The C150 and C300 systems have a dedicated management port and a
management routing table that is separate from the IP routing table.
Configuring the system for Telnet is a three-step process:
Configure the Management Port IP Address
Assign IP addresses to the management ports in order to access the system
remotely.
NOTE:
Assign different IP addresses to each RPM’s management port.
Configure a Management Route
Define a path from the system to the network from which you are accessing the
system remotely. Management routes are separate from IP routes and are only
used to manage the system through the management port.
Step
Task
1
Configure an IP address for the management port.
2
Configure a management route with a default gateway.
3
Configure a username and password.
Step
Task
Command Syntax
Command Mode
1
Enter INTERFACE
mode for the
Management port.
interface ManagementEthernet
slot/port
CONFIGURATION
2
Assign an IPv4 or
IPv6 address to the
interface.
ip address
{
ipv4-address
|
ipv6-
address
}/
mask
INTERFACE
3
Enable the interface.
no shutdown
INTERFACE