Dell Force10 MXL Blade Getting Started Guide - Page 8
MXL 10/40GbE Switch: Plug-in Modules
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Then save the configuration and reload the switch. FTOS# write memory FTOS# reload Figure 1-2. MXL 10/40GbE Switch: Plug-in Modules 2-Port 40GbE QSFP+ Module 4-Port 10GbE SFP+ Module 4-Port 10GBASE-T Module (100Mb/1GbE/10GbE) NOTE: You can only hot-swap plug-in modules of the same type without requiring a reboot. For example, you can replace a 2-Port 40GbE QSFP+ module only with another 2-Port 40GbE QSFP+ module. On the MXL 10/40GbE Switch, you can configure uplink ports of the same speed on different modules in the same link aggregation group (LAG). You can also use individual ports for uplink connections. NOTE: A maximum of 16 ports are supported in a LAG. For switch stacking, you must use a 40GbE port on the base module or on a 2-Port 40GbE QSFP+ plug-in module. Stacking is not supported on 10GbE ports. All FlexIO plug-in modules, transceivers, and attach cables are sold separately. 8 Hardware Overview