Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 114

www.dell.com | support.dell.com Table 6-4. ACL Resequencing Example (Resequenced) seq 15 permit any host 1.1.1.3 seq 20 permit any host 1.1.1.4 Resequencing an ACL or Prefix List Resequencing is available for IPv4 and IPv6 ACLs and prefix lists and MAC ACLs. To resequence an ACL or prefix list use the appropriate command in Table 6-5. You must specify the list name, starting number, and increment when using these commands. Table 6-5. Resequencing ACLs and Prefix Lists List IPv4, IPv6, or MAC ACL IPv4 or IPv6 prefix-list Command resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum Step-to-Increment} resequence prefix-list {ipv4 | ipv6} {prefix-list-name StartingSeqNum Step-to-Increment} Command Mode Exec Exec Figure 6-19 shows the resequencing of an IPv4 access-list beginning with the number 2 and incrementing by 2. Figure 6-19. Resequencing ACLs FTOS(config-ext-nacl)# show config ! ip access-list extended test remark 4 XYZ remark 5 this remark corresponds to permit any host 1.1.1.1 seq 5 permit ip any host 1.1.1.1 remark 9 ABC remark 10 this remark corresponds to permit ip any host 1.1.1.2 seq 10 permit ip any host 1.1.1.2 seq 15 permit ip any host 1.1.1.3 seq 20 permit ip any host 1.1.1.4 FTOS# end FTOS# resequence access-list ipv4 test 2 2 FTOS# show running-config acl ! ip access-list extended test remark 2 XYZ remark 4 this remark corresponds to permit any host 1.1.1.1 seq 4 permit ip any host 1.1.1.1 remark 6 this remark has no corresponding rule remark 8 this remark corresponds to permit ip any host 1.1.1.2 seq 8 permit ip any host 1.1.1.2 seq 10 permit ip any host 1.1.1.3 seq 12 permit ip any host 1.1.1.4 114 | Access Control Lists (ACLs)